Hello there, todays blog post is to share a little inspriation with you from the IndigoBlu TV Design Team 'The BluBirds'. The team are working towards bringing you some inspiration along with quick and easy instructions every couple of weeks highlighting some of the IndigoBlu Stamps and Products.
Today we have created different ways of using the 'Artist' Stamp set range.
Grab a cuppa and enjoy.
|ART GIVES YOU WINGS|
The first person up is Julie Atkinson. Check out her blog Here!
1. Take an A5 card blank. Cut a panel of black card to measure 12.3 x 17.5cm. Cut a panel of Indigo Blu’s White Perfect Stamping Card to measure 12 x 17.2cm.
2. Using the white card panel, spritz along the top with water (don’t oversaturated the card, just enough to allow the paints to move).
3. Mix Blue Luscious Powder with water to create a loose paint. Add large drops randomly along the top of card where you’ve applied the water. Carefully spritz with water to encourage the Luscious Paint to drip, once again add just enough water to encourage flow.
4. Repeat the last step with Teal, Green and Mermaid’s Tail luscious powders.
5. Once dry, ink the paint brushes stamp from the ‘Art Studio Stamp Set’ using Versafine Onyx Black Ink. Stamp the image along the top of the card. Quickly apply clear embossing powder to the stamped area and heat (embossing the image will help it to stamp out against the mica in the luscious powders)
6. Stamp ‘Create’ at the bottom right hand side
7. Mat and layer your panels to finish
This next inspiration is from Aitch. Check out her blog Here!
1.On a greyboard tag I stencilled with true grit through the 'Blueprint' stencil. When dry I covered with white gesso, 'Teal for Two' and 'Purple Rain' blending the wet colours. I then lifted off some of the damp paint with a cloth and darkened a little with 'Ugly Duckling'
2. Die cut 2 hearts, one from corrugated card and one from hessian backed with paper. I painted the card heart with 'Mulberry Bush' then, using my fingers I highlighted the ridges with 'Bronze' Luscious. I dabbed a little of the bronze onto the paper side of the hessian heart and stamped 'Create' from 'Art Studio'
3. stamp the wings from 'Art Gives You Wings' coloured them with 'Verdigris' Luscious and then cut them out. I then stuck the wings and hearts together and added some paperclips.
4. Replace the Blueprint stencil over the tag and went through with black versafine and around the edges of the tag. I then added clear embossing powder over the whole tag and heated.
5. Add cogs and arrow die cuts to the tag and glued down the heart.
6. Finally I stamped a sentiment from 'Art Studio' on corrugated card and tore it out, glued it to the bottom of the tag and added another paper clip. I added bronze dots and a copper binder clip to the top and finished by darkening some areas with black ink.
And next we have a card from Carolyn Lakin. Check out her blog HERE!
1.Created this simple card using Transluscent acrylic paint in ‘IndigoBlu’ and white card.
2. Cut the white card into a square slightly smaller than the 150mm white card blank. Repeat stamp the brushes/pencils across the bottom of the card using the IndigoBlu paint colour.
3.Colour wash the brushes/pencils with watered down paint to give a watercolour effect.
4.Edge the card with the same colour using a piece of phat foam. Stamp the quote in the same colour onto a separate piece of card and cut into strips.
5.Mat and layer the stamped card onto the card blank and adhere the quote strips onto the card.
This Inspiration piece is from me, Sue Ralph. Check out my blog HERE!
Step 1. Using a pre-washed tee-shirt I decided to do some tie-dying using the Cottage Garden Acrylic paints which are also fabric paints. I mixed the following paints, Sleeping Beauty, Park Lane, Grandma’s Teacup & Kingfisher Blue up into separate plastic cups with a little water.
Step 2. Using some small glass pebbles I took one at a time and gathered up some of the tee-shirt material from just one side of the shirt and wrapped some rubber bands up and around the material to keep the pebble in place. I did the same thing all over the tee shirt including the arms.(Learning from my mistake, don’t wrap the rubber bands to tightly as the paint doesn’t spread so well and stretches the tee-shirt material)!
Step 3. I then dipped the material covered pebbles into different colour paints then went back to each part of the wrap and added different colours with a paint brush. Once done leave to dry out.
Step 4. Once completely dry, undo the rubber bands and take out the pebbles. Iron the T-Shirt to set the paints using some copy paper over the painted areas to protect your iron and board.
Step 5. Hand wash the T-shirt and dry. Then using Stazon Black Ink stamp out images from “Artist Tools”, “Art gives you wings“ and “Art Studio” around the Tie-Dyed patterns.
The final inspiration piece is from Emma Blake - Check out her Blog HERE
2. I then stamped them again onto scrap paper and cut them out to make a mask.
3. I covered the embossed tubes with the masks and made a wash with Luscious. I kept adding and taking away the wash until I was happy with the coverage being careful not to wet the tag to much so the mask didn't get soggy.
4. Once dry I used the limited addition dotty circles and stamped with Stazon ink.
5. I them removed the masks and painted in the painttubes.
6. To finish, I stamped my sentiment onto card and used foam pads to lift it off the tag slightly to make it stand out. I them used a dark ink pad around the edges of the sentiment and tag and stuck the sentiment into place.
We hope you enjoy creating one or more of these of your own xx
We would love to see how you have used these stamps so please stop by the I Love IndigoBlu Facebook Page and share your creations with us.
Happy Crafting xx